← WikiLED A–Z

WikiLED · LED-Glossar

Controllers

Controllers are used for the precise current control (switching on and off) of LED lighting. Even small changes in voltage can increase the LED current and light emission so significantly ...

Controllers are used for the precise current control (switching on and off) of LED lighting. Even small changes in voltage can increase the LED current and light emission so significantly that they can be destroyed in a very short time. Therefore, precise lighting regulation is difficult to achieve via the voltage supply alone. With a controller, an output current can be set with an accuracy of 1 mA, regardless of the voltage supply. The brightness of an LED is approximately proportional to the current.
An LED controller (LED driver) offers the following advantages:
– high light stability and performance,
– highly controlled,
– flexibly configurable,
– very efficient.
LED controllers with a pulse function (strobe control) allow LEDs to be flashed for short periods. Strobe operation refers to illumination times of < 1 ms. Longer illumination times are referred to as switching or pulse operation, which is equivalent to continuous operation in terms of current and power.
In strobe operation, an LED can be overdriven, operating it briefly with a very high current. This over-strobing allows for a brightness increase of up to 10 times relative to continuous or pulse operation. Additionally, the maximum Irradiance of the LED is available within a few microseconds (short latency). The maximum permissible strobe current depends on several factors: rated power in continuous operation, LED characteristic curve, pulse duration, total cycle time, and operating temperature.
Over-strobing offers the following advantages:
– reduction of the influence of ambient, external, or other interfering light,
– increase in LED lifespan,
– synchronization between the camera, lighting, and the objects to be inspected,
– reduction of motion blur,
– reduction of power consumption, and
– minimization of heat generation.
In strobe operation, the synchronization of image acquisition with the strobe lighting is particularly important. The exposure time of the camera should be selected to be longer than the strobe duration, with the strobe duration being the actual exposure time.
Controllers are triggered via fast opto-decoupled PLC and/or TTL switching inputs. Tolerances in trigger timing, delays, adjustable current ramps, and signal jitter must be taken into account.
Controllers can already be integrated into the lighting or are available externally, e.g., also integrated into the cable.

You can find controllers from Büchner Lichtsysteme here.