← WikiLED A–Z

WikiLED · LED-Glossar

Strobe Control

The performance of LEDs and LED lighting is often limited by the self-heating of the components. One way to increase performance is the use of strobe controllers or flash controls. Since ...

The performance of LEDs and LED lighting is often limited by the self-heating of the components. One way to increase performance is the use of strobe controllers or flash controls.
Since camera systems, with the exception of line scan cameras and high-speed cameras, usually only capture short images at a certain frame rate, it can be advantageous to synchronize the lighting with the image acquisition and switch it off during the dead time between image captures.
Additionally, it is usually possible to supply LED lighting with a disproportionately higher current during short flash durations than in continuous operation. The most sensitive part of an LED is the so-called “active zone,” in which the electrical current is converted into light converted. With very short pulses, the active zone does not have time to heat up accordingly. For this reason, in the microsecond range, even with very high-quality LEDs, twice the continuous current is often permissible.
Regarding the shortness of the light pulses, there are almost no restrictions for the LEDs themselves. However, high-frequency effects and the required precision of the current regulation ensure that strobe controllers can usually provide a minimum pulse duration of 1 µs. The maximum length of the pulses usually depends on the power supply of the controller and/or the internal storage capabilities of the controller. Additionally, the required flash current, the necessary voltage, and the dissipation of the controller’s power loss play a role.
Strobe controllers usually have either fixed operating values for current, voltage, and flash duration or are configurable via digital communication protocols or web interfaces. The pulses themselves are then triggered during operation either by the camera or a PLC via an analog signal or by computer-controlled digital signals.
Strobe controllers for low to medium power can be integrated into the lighting itself or in the supply line. High-performance controllers usually consist of modules of various designs, which are often housed in the control cabinet.
See also LED drivers.